4.9 from 763 reviews

26 San Diego neighbourhoods

$89 service call, waived with the repair

(760) 330-4020
Whirled Service Appliance repair · San Diego (760) 330-4020

A maker we work on

Thermador Appliance Repair in San Diego

Thermador belongs to the same group as Bosch and Gaggenau, and its dishwashers in particular share their architecture down to the fault codes. The cooking products are where Thermador is genuinely its own thing: star burners, heavy pro-style ranges, and induction cooktops with more electronics under the glass than most.

What Thermador builds

The Pro Harmony and Pro Grand ranges are the recognisable products, with the star-shaped burners that spread heat wider than a conventional ring and simmer lower than most. Alongside them Thermador builds Masterpiece and Professional wall ovens, Freedom induction cooktops, Sapphire dishwashers and refrigeration columns. The dishwashers are effectively Bosch underneath, which makes them predictable. The cooking products need model-specific parts ordered against the plate, and that is worth planning around rather than discovering late.

What we are called about

Star burner clicking without lighting

A spark electrode wet from a spill, a burner cap out of position, or a spark module that has failed and fires every electrode at once. On the pro ranges the caps are heavy and easy to seat slightly wrong after cleaning, which is the most common cause of all.

Dishwasher stopping with a drain fault

Sapphire dishwashers share the Bosch filter and pump layout, so the finds are the same: a blocked filter stack, a jammed impeller or the check valve in the sump. Anything that gets past the filter arrives at the pump whole, because there is no grinder.

Wall oven temperature drifting

The temperature sensor drifts long before an element burns out. An oven running well under its set point while both elements glow normally is nearly always the sensor or the control calibration, and it is measured with a probe rather than judged from a thermometer on the shelf.

Induction cooktop shutting itself down

Induction tops shut off when the electronics under the glass get too hot, which usually means the cooling fan or its intake is blocked rather than a failed board. A hob that works for twenty minutes and then quits is following that pattern almost every time.

Refrigeration column running warm

On the built-in columns the condenser and its fan sit behind the grille and clog like any other. Beyond that the usual causes are the evaporator fan or a defrost fault. Parts here are model-specific and ordered against the serial plate.

Thermador repairs by appliance

Reviews

What people wrote afterwards

4.9 from 1,042 reviews

  • ★★★★★

    The fresh food side warmed up while the freezer stayed cold. Its evaporator fan motor had seized. He replaced the motor and cleared the drain hole in the rear panel, which had iced over as well.

    Beatriz N.La Jolla

  • ★★★★★

    Mid-rise building with in-unit laundry, and mine had stopped mid-wash with the door sealed. The main control board was dead. He confirmed that with a meter instead of guessing, ordered the part, and came back to fit it.

    Meredith Q.Bankers Hill

  • ★★★★★

    Its fan kept running long after the door was open and nothing would stop it. A relay on the control board had stuck closed. He fitted a new board and made sure the vent damper above was moving freely.

    Aleksandr H.Mission Valley

  • ★★★★★

    The alarm kept sounding overnight. Its door was not pulling shut because the lower basket had shifted forward and was holding it off the seal. He also replaced a cracked closer cam on the hinge.

    Elowen P.Serra Mesa

  • ★★★★★

    Loads were coming out soaking because the machine never reached spin speed. The motor control board had a burnt track across it. He returned with the board two days later and had it fitted in twenty minutes.

    Heriberto V.City Heights

  • ★★★★★

    It ran but the dishes stayed dirty and the top rack came out dry. Chopped food had blocked the filter and the middle spray tube had unclipped itself. He cleared and refitted both, with no parts needed.

    Gustavo N.Chula Vista

Answers

Thermador questions

Is a Thermador dishwasher the same as a Bosch?

Not identical, but close enough to matter. They share the group’s dishwasher architecture, the filter and pump layout and most of the fault reporting, with different racking, controls and trim on top. In practice a drain fault is diagnosed the same way on both, which makes them straightforward to work on.

Why do my star burners click after I clean them?

Because the caps are heavy and only light properly when they sit exactly in their locating ring. A cap a fraction out of place puts the flame port away from the electrode and the spark keeps firing. It is worth lifting and reseating each one before assuming an electrical fault.

Can you get Thermador parts in San Diego?

Dishwasher parts, yes, quickly, because of the shared platform. Range and cooktop components are ordered against the serial plate and take longer, particularly burner assemblies and control boards for older Pro models. We identify the part on the first visit so the wait starts immediately.

Do you handle Thermador warranty claims?

No. A warranty claim has to go through a factory-authorized provider, and that is not us. If the appliance is still covered, that route costs you nothing and should be used. Once the coverage has run out we work on these units with genuine Thermador parts ordered to the model.

Get it looked at

Have the Thermador model number to hand

The make, what the machine is doing, and how it is fitted — stacked in a closet or standing in a garage. That is usually enough to know what the visit involves.

(760) 330-4020 Book online

$89 service call, waived when the repair is approved.