4.9 from 763 reviews

26 San Diego neighbourhoods

$89 service call, waived with the repair

(760) 330-4020
Whirled Service Appliance repair · San Diego (760) 330-4020

Downtown San Diego · 92101

Microwave Repair in Downtown San Diego, San Diego

A microwave rarely fails all at once. In Downtown San Diego there is almost always an earlier sign, and it is usually the one people ignore for a fortnight.

Why Downtown San Diego is its own case

High-rise laundry closets are the constraint here. A stacked washer-dryer has to come out to reach anything behind it, and there is rarely more than an inch either side, so the pair gets walked out on furniture sliders rather than tilted. Most buildings want the freight lift reserved and the corridor protected, and some will only allow it in set hours. Give us the building name and the management contact when you book and we handle that. Venting is the other recurring one: long shared duct runs collect lint far from the machine, which is why a dryer that tests fine still takes three cycles.

The first ten minutes

Every microwave repair opens the same way: is there power at the socket, what does the rating plate say, when did it start, and is the machine flagging anything on its own display. Cut that short and you end up buying a part that was working perfectly while the real fault sits untouched.

Diagnosis

Common microwave faults

01

Worn membrane keypad

How it showsOne row of buttons does nothing, the rest respond normally.

The repairReplace the touch panel; the control board is usually fine.

02

Door interlock switch out of sequence

How it showsDead unit and a blown line fuse, often after the door was slammed.

The repairReplace the switch set and adjust the latch so the sequence closes cleanly.

03

Failed magnetron

How it showsRuns a full cycle, turntable moves, food is cold.

The repairTest the high-voltage circuit first; replace the magnetron only if diode and capacitor are sound.

Other repairs in Downtown San Diego

Microwave Repair elsewhere in San Diego

Reviews

Nearby jobs

5 from 1,078 reviews

  • ★★★★★

    The built-in went completely dark one evening. One of the door interlock switches had failed open. He replaced the set of three rather than only the bad one, which he said is the sensible way to do it.

    Yusuf B.Downtown San Diego

  • ★★★★★

    The door catch stopped holding so the thing would not run at all. He fixed it properly with a new latch board and hooks. The arrival window was tight and he ran late, although he did call ahead.

    Bianca R.City Heights

  • ★★★★★

    The plate turned but nothing ever got warm. Its magnetron had failed. He explained why guessing at that part is a bad idea, tested the high voltage side properly, and only then fitted the replacement.

    Estelle J.La Jolla

  • ★★★★★

    Loft with the microwave built into a brick surround, so getting it down was awkward. He took his time and did not chip anything. A failed door switch was the fault, replaced, and back up on its brackets.

    Casper N.Gaslamp Quarter

  • ★★★★★

    Its fan kept running long after the door was open and nothing would stop it. A relay on the control board had stuck closed. He fitted a new board and made sure the vent damper above was moving freely.

    Aleksandr H.Mission Valley

  • ★★★★★

    The turntable stopped turning and the motor below it was humming away. He lifted the unit out, fitted a new turntable motor, and cleaned the roller track, which was full of crumbs and had been dragging.

    Ximena L.Chula Vista

Answers

Questions

Do you come out to Downtown San Diego?

Downtown San Diego is on the list — all 26 neighbourhoods here are. You pay $89 for someone to come and find the fault, and that comes off the moment the repair is agreed.

My microwave is in a closet — is that a problem?

Not at all, but tell us when you ring. A stacked or built-in pair has to come out before anything can be measured, and knowing beforehand means the right amount of time is set aside instead of a second trip.

Why does the fan keep running after I open the door?

On over-the-range units the fan runs on to cool the magnetron and the cavity, and on some models it also responds to heat rising from the range below. A fan that never stops points at the thermostat that controls it, or at a control board stuck in the cooling state.

Get it looked at

Microwave Repair in Downtown San Diego

The make, what the machine is doing, and how it is fitted — stacked in a closet or standing in a garage. That is usually enough to know what the visit involves.

(760) 330-4020 Book online

$89 service call, waived when the repair is approved.